Piezo Motion's electronic driver PCB has been designed to provide an economical user-control interface compatible with all Piezo Motion piezo motors. Each driver PCB is supplied pre-programmed for the specific motor model and is software configurable to provide optimization of drive signals and integrated controls. The primary purpose of the driver PCB is the formation of electrical pulses with specific frequency and amplitude for excitation of the piezo motor.

Main Driver PCB

The driver PCB can be programmed to work in either open-loop or closed-loop modes. In open loop mode the driver PCB controls the motor as a standalone device without any positional feedback information.  When either the environmental temperature or the load of the motor changes the driver PCB implements stabilization of the pre-programmed current (which is different for each model of piezo motor). This provides maximum speed of movement according to the published motor specifications.

Manual control of motor motion can be performed by pressing either of the two Manual Control Buttons located on the driver PCB. External control of the motor is implemented by applying a logical TTL “0” to either of the two independent External Input Control pins (pin 1 and pin 2) located on the driver PCB. Input to these pins controls the direction of movement of the motor. A third pin (pin 3) is Ground. Motion is stopped by apply a logical TTL “1”.

The electronic driver PCB enables precision motion control of the piezo motor via a microcontroller based 12 V DC digital system, which also allows for user generated inputs for motion control.

The driver assembly (Main PCB) is comprised of five main sections as shown in the block diagram. The Power Supply (PS), accepts a 12 V DC input through a DC power jack with a 2.0 mm center positive pin. The 12 V is filtered then regulated to 5 V DC and filtered again to provide the board operational voltage.

Block Diagram of Driver Board (with optional Daughter Board and Encoder)

The Direction Control Unit (DCU), includes manual (push button) directional control signal inputs to the microcontroller (MC) for continuous piezo motor operation. This is implemented through active TTL low inputs to the microcontroller. An external control input (3 Pin connector) signal interface is included to facilitate user generated signal or pulse train controls for stepping mode operation (i.e. Pulse Width Modulation, “PWM”).  The Current Sense Unit (CSU) monitors current during motor operation.

The Microcontroller (MC), provides software-based control of motor motion in response to directional control inputs. When directional control signals are received, the microcontroller generates enable control output signals proportional to the control signals, and current feedback (via CSU) to the Driver (DR). In PWM mode of operation, the pulse width of the driver enable signal determines the amplitude of motion. A current negative feedback input is used by software to determine the optimal excitation frequency of the piezo motor to maintain the required current.

The Driver element (DR) is comprised of two gate driver ICs with FETs (to provide drive current) and step up voltage transformers. The Driver section uses the supply 12 V DC. The enabled gate driver amplifies the 5V TTL phase signals to a 12 V gate drive signal that switches on the FETs. When the FETs are active, the transformer steps up the ultrasonic signal voltage to the level required for excitation of the piezo motor (which can be between 30 V to 120 V depending on piezo motor model). Channel drive current is also detected within the Driver element, where it is amplified then integrated to provide an analog signal proportional to the channel drive current. This current sense feedback is used to optimize motor control and performance. Activation of motor motion in a specific direction is performed by command from the microcontroller.

In closed-loop control (feedback control) mode, an additional daughter PCB is mounted on driver PCB (see Motion Control Closed-Loop). Feedback from an external optical encoder, mounted on the piezo motor, is fed to the daughter board and used to close the loop. The position and speed of the motor can then be controlled through an elaborate set of commands via either a USB port (through Piezo Motion’s GUI) or serial (RS 232) port commands.

Connect With Us


Piezo Motion

6700 Professional Pkwy
Sarasota, FL 34240,
United States
(941) 907-4444

> Directions
> Terms & Conditions
> Privacy Policy